I set out to be a little more thorough in my antenna launching this morning. Here are the basic tools I used:
It's been a busy weekend. Allow me to be more specific, I used a fishing rod with a weight tied to the end of the line, a spool of twine, and a pair of nail clippers. The steps were:
1. Toss the weight over a higher tree limb
2. Tie twine to the end of the fishing line with the weight
3. Pull the fishing line and the twine back over the limb
4. Detach the fishing line
5. Attach the antenna to the twine.
6. Use the twine to pull the antenna up towards the limb
7. Anchor the twine below.
8. Repeat with the other end of the antenna
Here's 'a picture of the antenna's center when all was said and done
Comments
Post a Comment
Please leave your comments on this topic: